All information conatained herein is subject to change without
notice.
For more information-consult your nearby Continental Field sales representative.
|
ARC
STUD LOCATION TEMPLATE & BUSHING DESIGN
 This
method of templating is recommended for use with FB ferrules. The template
is usually a steel plate 3/32" to 3/16" thick. Spacers are required to
allow the gases to escape during the welding cycle. The ferrule can be
held by a standard ferrule grip or where clearance is prohibitive
a tube type set-up can be used.
The recommended hole sizes on the template to locate the ferrules should
equal the maximum outside diameter of the ferrule plus 1/32". Holes may
be drilled or bored at required locations. See stud specification sheets
for ferrule details.
 This
method of templating is recommended for use with all arc stud styles.
The design makes it possible to accurately hold angular alignment of the
studs as well as stud location. The template should be made of ebonite
or masonite of a thickness sufficient to afford good alignment. Template
bushings may be used to insure greater accuracy and extend the life of
the template. Standard ferrule grips are used with the tube adaptor. This
permits standardization of templates since it is only necessary to change
the ferrule grip to weld studs of different diameters.
The hole diameter of the bushing or template should be approximately .010
larger than the maximum outside diameter of the template tube adaptor.
|
||||||||