|
CAPACITOR DISCHARGE
|
ARC
|
| MATERIAL: |
Standard in low carbon steel, 302/304/305 stainless,
and 6061, & 5000 series aluminum. Brass and other grades of
stainless steel are also available. |
Standard in low carbon steel and 302/
304/305 stainless. Aluminum, monel, inconel, and other grades of
stainless steel are available.
|
| PLATING: |
Copper plating is standard. Cadmium, Nickel, Zinc,
and other platings are available. |
Cadmium to ASTM-A 165 type TS, zinc to
ASTM-B 633 (formerly A 164) and other platings are available. Nonweldable
plating is removed from the weld end to avoid contamination of the
weld. |
| ANNEALING: |
All low carbon steel and stainless steel studs are
annealed where required. |
Low carbon steel can be annealed to a
maximum of 75 Rockwell B and stainless steel to a maximum of 90
Rockwell B. |
| THREADS: |
UNC-2A is standard for external threads prior to plating
and UNC-2B for internal threads. Metric and other thread sizes are
available.
|
UNC-2A is standard for external threads
prior to plating and UNC-2B for internal threads. Metric and other
thread sizes are available. |
| WELD BASE: |
Flanged, small-flanged, and non-flanged are available.
|
1/4" dia. and over and solid flux.
Diameters under 1/4" are standard pointed, and flux is optional.
|
| STUD LENGTH: |
CD studs have no appreciable length reduction after
welding. |
CONTINENTAL arc stud length designations
are BEFORE WELD; AFTER WELD lengths are shown in the table below. |
| |
|
STUD DIAMETER
3/16" thru 1/2"
5/8" thru 7/8"
7/8" and over
1/8" wide rectangulars
|
APPROX. REDUCTION.
1/8"
3/16"
1/4"
1/8"
|
| FERRULES: |
Does not apply to CD |
All orders include ferrules when they
are required. |
